Adata SP300 Spezifikationen PDF herunterladen (Seite 32)

– 28 –

6-1. Cutting Method

Cuts recording paper into continuous forms connected at only one point remain-

ing uncut between adjacent forms.

Only one sheet of paper can be cut each time.

6-2. Cutting position

The paper is cut approximately 21.7 mm above the printing head.

Fig. 6-1 Cutting method Fig. 6-2 Cutting position

6-3. Auto cutting control codes

Refer to the control codes of chapter 10.

6-4. Other position to be observed

1 When continuously cutting for more than 12 minutes, make a maximum of 10

cuttings per minute.

2 When using for a long time, paper dust will gather around the cutter.

Therefore, make sure to clean periodically. If paper dust is not removed,

normal paper feeding may become impossible.

6. AUTO CUTTER (Auto-cutting models only)

Center of printer

Partial cutting

with one uncut

point left

Cutting position

Approx. 21.7mm

Printing head

position

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 69 70

Keine Kommentare

Adata SP300 Spezifikationen Seite 32