Adata SP300 Spezifikationen PDF herunterladen (Seite 5)

– 1 –

1. CONTROL PANEL

1-1. Basic Operation

1 “ON LINE” switch

Switches the printer between “ON

LINE” and “OFF LINE”. When-

ever the printer switches between

“ON LINE” and “OFF LINE”, the

buzzer gives one short beep (“ON

LINE” and “OFF LINE”, switching

is possible only when the paper is

loaded in the printer.)

2 “FEED” switch

• When this switch is pressed and

then released within 0.5 sec.,the

paper feeds one line.

• When this switch is depressed for

more than 0.5 sec.,the paper feeds

continuously.

(The above paper feed operation

is possible for both “ON LINE”

and “OFF LINE” modes.)

3 “POWER” lamp (green LED)

• Lights when the power for the printer is on.

4 “ALARM” lamp (red LED)

• Lights when the paper is out.

If the paper is out, load a new roll then press the “ON LINE” switch.

• Flashes when the front cover is open or a mechanical error (motor lock etc.)

occurs. The buzzer will give one short beep followed by a long beep.

Mount the front cover properly and press the “ON LINE” switch. If the

buzzer still sounds and the “ALARM” lamp flashes, this signifies that a

mechanical error has occurred. Locate the cause of the error and turn the

power for the printer off and back on again to reset the printer.

(In case of a mechanical error, the data will not be cleared even if the power

is turned off.)

5 “ON LINE” lamp (green LED)

LED lit: Printer is ON LINE

LED off: Printer is OFF LINE

LED flashes: Validation printing mode is set.

When all lamps 3 to 5 light simultaneously and the buzzer sounds continu-

ously, a CPU error has occurred. In case of a CPU error, turn off the power then

turn it on again. When turning off the power, the data will be cleared.

POWER

ALARM

ON LINE

FEED

Fig. 1-1 Control panel

1 2 3 4 5 6 7 8 9 10 ... 69 70

Kommentare zu diesen Handbüchern

Keine Kommentare

Adata SP300 Spezifikationen Seite 5

Kommentare zu diesen Handbüchern